Tips, reviews, and secrets for riding and maintaining dirt bikes.
7 Tips To Make Your Dirt Bike Run Again De-Winterize
It’s almost February, and you know what that means…. Spring is right around the corner! For those of us that don’t live in the southern states, unfortunately, we have to Winterize our dirt bikes and most other motorized toys. I have a strong dislike for the cold, and knowing that warmer weather is just a couple months away makes me even more anxious to get my bikes out. But, before you pull it out of the garage/shed from storage and tear it up again, there’s some things you’ll want to do to make sure it’s going to run right. This can also be helpful for people that have recently bought a dirt bike that has been sitting in someones barn for years.
Yes, I know it may just be dusty, but unless you thoroughly washed it before you put away last fall, it’s a good idea to scrub everything down. You will see the effect of this years down the road; your dirt bike will still look like new (besides the worn paint), but others will have crusty, oil-stained, dirt-colored bikes. This is usually on the bottom of bikes, but if you take care of it, then it will be easier to sell in the future.
Clean The Carburetor
Dirt bike carburetors often get dirty and gummed up from sitting for a couple months. Even if you can get the bike to start up, chances are is that it’s not going to run right. The cheapest way to fix this is with a carb cleaner and an air gun. You should pull all of the jets out and thoroughly clean them. The smallest amount of dust can cause problems, even if you can’t see it. Then you’ll want to spray in the carb through all of the passages. It may take a couple times to clean everything out.
The more expensive, yet much more effective way, is with an Ultrasonic carburetor cleaner. These were originally used for cleaning small jewelry items, but the half gallon tank can clean dirt bike carburetor parts, as well as injector parts (for you FI guys). It uses special liquids with an ultrasonic frequency that washes away all the dirt, grease, and grime off of parts. Just stick your parts in the tank and let them sit in there for a few hours and they’re good as new!
After sitting for a while, oils and liquids gather dirt and impurities. It’s best to drain the old fluids and put in some new oil. You don’t want your engine to lock up on your first ride of the season when it could have been prevented with $10 of oil.
Air filters should be cleaned/replaced every few rides, and sometimes sooner, depending on the riding conditions. It protects the engine by keeping dirt and other foreign materials out of the carburetor. Dirt is an engines worst enemy, so don’t forget to clean the air filter. This goes for the oil filter as well, as it collects impurities in the engine oil. The oil filter on a four-stroke should be replaced every other ride. They’re dirt cheap (no pun intended), and will prevent a major failure later on. Two-strokes don’t have oil filters, so that’s one less thing to maintain.
If you want your chain to stay in one-piece, lube it up before you go on your first trail ride or moto session. A rusty chain can and will cause problems sooner rather than later. I don’t think I need to go into much detail, but a broken chain can blow a hole through the left side of the crankcase…
Fresh Spark Plug
A fouled plug is one of the worst problems that can happen on a long trail ride, especially if you forget to bring a spare. You should replace your dirt bike’s spark plug at least once a year. Not only does it give the bike more power compared to an old and fouled plug, but it will start and run much better. Don’t forget to pack spares!
Oil It Up
If you live in a relatively humid environment and your bike has been sitting for more than a couple months, there’s a good chance the cylinder walls have started to rust on the surface. This can be really hard on it and the piston rings on the first start up. To reduce the chances of a failure and damage, pull the spark plug off and pour a light amount of oil down to the cylinder. Then, slowly kick the bike over to get the oil to cover the walls.
Yes, technically this is number eight, but it’s very important. Gas goes bad fairly quickly, especially if it has additives or premix. So, drain all of the gas out of the tank and/or carb if you haven’t already, and put in some fresh gas. Old gas can and will cause problems, especially on higher performance bikes that require fine carb-tuning.
If you’ve completed all these steps on how to de-winterize your dirt bike, it should be more than ready to go! Have fun, and ride smart!